Aoki AL-500LL-50S

Used AOKI AL-500LL-50S injection molding machine - Year 2018Technical Specifications & Performance DataThe AOKI AL-500LL-50S is an injection molding machine designed for PET container manufacturing through an integrated injection and blow molding process. This used bottling line asset is configured with 7 cavities, supporting efficient production of molded containers for industrial packaging and beverage production applications.Manufacturer: AOKI Technical Laboratory, Inc.Model: AL-500LL-50SManufacturing year: 2018Including: compressor and chillerCavity configuration: 7 cavitiesScrew diameter: 64 mmInjection capacity: 522.8 cm³/shotInjection mold clamping force: 500.3 kNPreform length below neck: 150 mmBlow mold clamping force: 608.3 kNBlow air pressure: 3.0 MPaAdvanced Automation & Control SystemsThe machine is equipped for three-phase electrical operation at 380 V and 50 Hz. Its installed electrical load is 94.0 kW with a current requirement of 168 A. The injection molding platform combines turntable and screw drive functions with hydraulic and pneumatic utilities for controlled molding cycles.Three-phase electrical supplyVoltage: 380 VFrequency: 50 HzPower: 94.0 kWCurrent: 168 AHydraulic pressure: 17.5 MPaPneumatic pressure: 3.0 MPaWater supply pressure: 0.3 MPaProduction Line Integration CapabilitiesThis AOKI injection molding machine can be positioned upstream of a used bottling line to produce PET containers directly from resin, reducing dependence on externally supplied bottles. Machines of this type are suited to integrated industrial packaging layouts where container production is coordinated with downstream handling, filling, capping, labeling and secondary packaging equipment.The 7-cavity configuration supports repeatable container molding for beverage production. Integration planning should consider molded-container discharge, conveyor connection, compressed-air supply, chilled-water services and downstream accumulation capacity.Machine Condition & Maintenance HistoryThe machine is offered as a second hand industrial packaging asset and is ready for operation. No mold is included with the machine, and auxiliary parts are not included. Buyers should plan tooling selection and auxiliary equipment integration according to the required container design and production process.Operational Performance & VersatilityThe AL-500LL-50S combines injection molding and blow molding functions for PET container production. Its technical configuration includes a 600 mm injection mold clamping stroke, a 115 mm blow mold clamping stroke, and a maximum chilling capacity of 51.2 kW. The machine requires cooling-water management and compressed air to support stable molding operation.Injection capacity varies according to the resin and molding parameters used. Actual operating pressure is governed by the installed machine and mold specifications, allowing the process to be configured around the selected tooling and required container geometry.Installation Requirements & Site PreparationThe machine requires a prepared installation area with three-phase electrical power, hydraulic services, pneumatic supply and cooling water. Overall dimensions including the safety door are 6.39 m in length, 3.22 m in width and 3.49 m in height. Approximate machine weight is 11,600 kg, requiring suitable floor loading capacity and handling equipment during installation.Operation air consumption is 519.5 L/min based on a 16-second cycle. A compressor sized at 1.5 to 2 times the required air volume is recommended for stable operation. Cold water is required for the water-cooled chiller, and machine cooling-water demand is 139 L/min.Safety Standards & Compliance CertificationThe machine carries CE marking and is designed with a safety-door enclosure. The stated overall dimensions include the safety door. Safe installation requires appropriate guarding, electrical isolation, pressure-system controls and access around the machine for operation, maintenance and mold changes.The listed machine weight excludes molds, safety guards including safety doors, and hydraulic oil. Tooling, utilities and protective systems should be assessed as part of the commissioning scope for this injection molding machine.